Yetter 1310-001, Руководство оператора

Страница: 8 / 28

8
TROUBLE SHOOTING
This is a list of many of the possible problems, causes and solutions to problems that you may
encounter. If you have a problem that is not covered, please contact your dealer or Yetter
Manufacturing Co. at 1-800-447-5777. Before you call, please have your operator’s manual and the
model number of the machine.
PROBLEM
Drive belt will not run or
runs slow.
Belt edge is frayed.
Tender belt will not turn.
Engine will not start.
Electric switch will not
work.
Seed will not flow.
Tender tube will not rise
with hydraulic cylinder.
CAUSE
Pressure regulator is
bypassing oil
Hydraulic motor coupling
is loose.
Belt not aligned.
V-belt is loose.
Key sheared on pulley.
Fuel shut off.
Poor battery connection
or dead battery.
Poor connection.
Broken wire.
Blockage exists.
Feed gates are shut.
Engine not running.
Hydraulic motor drive
coupling is loose.
SOLUTION
Turn the adjustment bolt
clockwise.
Connect the shaft drive
coupling.
Align and tension belt.
Make certain belt is not
rubbing against anything.
Tighten V-belt.
Replace key.
Turn on fuel.
Tighten and test battery.
Make sure toggle switch
is off when not in use or
disconnect battery
ground cable.
Check connections.
Test wire for continuity.
Remove blockage.
Open feed gate.
Start engine.
Connect the shaft drive
coupling.