Yeti Tool Ltd | Unit 12 Old Mill Road | Portishead | Bristol | BS20 7BX
14
CNC
STYLUS
–
QUICK
START
GUIDE
V1.1
7.4
Changing a blade
The cutting blade is held in place with a magnet which sits on a bearing. This allows the
blade to easily swivel and rotate.
To remove the blade, simply press on the ejection pin as shown below.
You can then remove the blade by pulling it out. Remember to replace the protective cap to
ensure your blade does not get damaged or blunted.
7.5
Setting blade height
When cutting vinyl, setting the correct blade height is especially important. If you do not
set the blade height correctly, you can end up cutting too far through your material, or not
far enough.
To set the blade height:
1.
Insert the blade you wish to use into the vinyl cartridge
2.
Loosen the gold locking ring on the vinyl cartridge
3.
Rotate the top part of the cartridge assembly until the blade extends from the
cartridge the correct amount
4.
Tighten the gold locking ring to fix the blade height
Содержание CNC Stylus
Страница 1: ......