40
main assembly Cont.
assembly
main assembly
the final bolts to secure on the link are the stiff
link h pinch bolts. Make sure that the tail ends of stiff link h are
centered the bearings as shown before tightening.
main assembly
once the stiff link h is centered, tighten the pinch
bolts using a 3mm allen key.
torque spec: 40-50 inch/pounds.
main assembly
after the axle is secure and the rear spacing is
150mm, you can tighten the pinch bolts on the stabilizing link. start
with the bolts on the main frame. Make sure the link is centered between
the bearings and the frame and tighten using a 4mm allen key.
torque spec: 40-50 inch/pounds.
main assembly
next, tighten the bolts on the stiff link i using a
4mm allen key.
torque spec: 40-50 inch/pounds.
51
52
49
50
main assembly
the final steps are to tighten the pinch bolts on the
swingarm. locate the bolts near the bearings and secure using a
5mm allen key.
main assembly
repeat this step for both locations and the opposing
swingarm.
torque spec: 125-150 inch/pounds.
53
54
Warning:
This step should only take place once the axle is secured and the
rear wheel spacing is 150mm
Warning:
This step should only take place once the axle is secured and the
rear wheel spacing is 150mm
Warning:
The Stiff Link H must be centered over the bearings of the
stabilizing link may not function properly.
Warning:
This step should only take place once the axle is secured and the
rear wheel spacing is 150mm
