Lightly apply pink Loctite to the collet axle
threads.
22.
23.
ASSEMBLY
ASSEMBLY
Slide the upper link over the lower pivot axle
sleeve on the front triangle. Ensure the Yeti logo
faces the front of the frame.
Lightly Grease the lower link axle and install it
through the link from the drive side of the frame.
Use a dead blow hammer to tap the axle into
place if needed.
05.
06.
08.
07.
Lightly apply pink loctite to the threads on the
lower link axle cap. Install and tighten the cap
into the lower link axle with a 5mm and 6mm allen
key. Tighten until there is no play between the
bearings and link and the link still moves freely.
Torque to 80-90 in/lb.
Create two collet bolt assemblies. Place a collet
wedge over each collet bolt and secure the
wedge with a retaining ring using a pair of lock
ring pliers. Prep the outside of each wedge and
the bolt threads with grease.
Slide the rear triangle over the eccentric and align
it with the main pivot bearings.
Lightly grease the shaft of the main pivot collet
axle. Insert the collet axle through the swingarm
and eccentric from the non drive side of the frame
and tighten with a 10mm allen key. Tighten until
the swingarm and bearings contact eachother
firmly but still move smoothly.
Torque to 40-45 in/lb.
09.
10.
11.
12.
Prepare a Ti male bolt with blue loctite and install
into the threads on the drive side of the eccentric
unit with a 5mm allen key.
Torque to 90-95 in/lb.
