22.
23.
assembly
assembly
lightly grease the threads on the stop bolt and
tighten into the eccentric housing with a 6mm
allen key. ensure the main pivot axle hole is
turned to 3 o’clock during this step
torque to 40-45 in/lb.
Grease the inside surface of the inner race
extender and place over the drive side dogbone
pivot bearing. repeat the process for the non-
drive side.
slide the upper link over the inner race extenders.
ensure the yeti logo faces the front of the frame.
Grease the shaft of the lower link pivot axle.
prepare the threads of the axle with blue loctite.
insert the axle through the link and tighten with a
6mm allen key.
torque to 90-95 in/lb.
05.
06.
08.
07.
slide the rear triangle over the integrated axles
and align it with the pivot pin axle hole.
Grease the main pivot axle and install it through
the swingarm and integrated axles from the drive
side of the frame. Use a dead blow hammer to
tap the pin into place.
apply blue loctite to the threads on the axle link
cap. install and tighten the cap into the main pivot
axle with two 6mm allen keys.
torque to 90-95 in/lb.
install the appropriate eyelet hardware into the
lower shock eyelet.
09.
10.
11.
12.
