28.
29.
tighten a bearing cap into the recess on the drive
side of the swingarm with two m5x0.8x10mm
shC bolts prepped with washers and blue loctite.
repeat the process for the non-drive side.
torque to 30 in/lb.
slide the shock extender into the swingarm just
below the dogbone. Orient the extender so the
portion with female threads is below the non
threaded portion of the extender.
Grease the shaft of a 303 wC male pin and
prep the threads with blue loctite. insert the pin
through the shock extender and into the female
threads on the drive side of the swingarm,
tightening with a 6mm allen key. repeat the
process for the non-drive side.
torque to 175-180 in/lb.
Orient the shock so that the piggyback is above
the shock body and towards the front of the bike.
turn the shaft so that the face of the rebound dial
is on the drive side of the frame and insert the
shock into the opening in the shock extender.
13.
14.
15.
16.
assembly
apply blue loctite to the threads on the shock
extender bolt. tighten the bolt through the shock
extender and shock with a 6mm allen key.
torque to 95-100 in/lb.
install the front of the shock onto the frame. insert
a 34 mm ti female bolt with a shock bolt washer
through the drive side of the frame and shock.
Use a ti male bolt prepped with a washers and
blue loctite on the nondrive side and tighten with
two 5mm allen keys.
torque to 90-95 in/lb.
18.
17.
assembly
inset a fork bumper into the recess on the drive
side of the frame. prep a m4x8mm shC bolt with
blue loctite and tighten the bumper to the frame
with a 3mm allen key. repeat the process for the
non-drive side.
torque to 10-15 in/lb.
19.
