7
Switching off the appliance
1. Turn off the water supply at the tap.
2. Press the trigger to reduce the pressure in the appliance.
3. Pull out the water inlet hose, and then let the machine run a few seconds to drain the
water of storing in the pump.
4. Switch off the appliance and disconnect the electric plug from the power socket.
5. Detach the pressure hose. To drain the residual water, lift up the jet gun and squeeze the
trigger.
See picture 6.
USER MAINTENANCE AND REPAIR
Disconnect from the electrical power supply before carrying out user maintenance.
Turn off the water supply at the tap and press the trigger to discharger the pressure.
Lubricate the fixing periodically using the lubrication oil.
When the water pressure is not consistent or too high, it shows the signal of defect hose
or accumulation of the Calcium in the nozzle.
Turn off the machine immediately.
Use the nozzle cleaner to clean the hose and the water inlet filter.
Change the defective filter.
Make sure that the machine is clean and clean the components when necessary.
Follow the operation-instructions for the different parts. Pluggable ring-nuts are used to
connect the gun, hose and other parts.
The seals of the ring-nut connections shall not be damaged
Turn the detergent tank and fasten it to the foam nozzle.
Connect the foam nozzle with the jet gun.
Turn on the machine. input the cleaning agent by a proportion of 1%. Warning: Use only
the cleaning agent supplied by the manufacturer or their after-sales service.
Keep the appliance safe and store them carefully in a secure dry place. Always store the
machine out of the reach of children.
Avoid storing the washer in temperatures below frost point.
Cut off the power if the appliance malfunctions.
On
OFF
Picture 6
