2
ADDITIONAL SAFETY INSTRUCTIONS
In order to safely use the cleaner, make sure that you have read all of these instructions
and checked the machine before operation. Have a try before the official use.
The machine, hose and plug must be checked before the operation. Defective parts
should be repaired by a specialist.
Do not direct the jet at the machine, socket and wire-connection.
Do not direct the jet at person and animals.
Check the hose connection before operation, the leaky and defective parts shall be
repaired or replaced immediately.
Do not touch the electrical plug or any wall socket with wet hands.
Use the handle grip to transport the machine, it’s forbidden to drag the power cord to move
the appliance.
When you unplug, grasp the plug instead of the cord.
Only use the power cord which with rubber insulation enclosure or protection enclosure.
Keep the plug and hose in dry place.
To prevent the maximum operating pressure, the outlet hose should be at least 9.8FT/3M
long.
Do not use the pressure cleaner in inflammable environment.
Take care of the kickback force and the sudden torque on the spray assembly when
opening the trigger gun. Always use two hands to grip the gun firmly before pressing the
trigger.
Only press the switch after the high pressure hose is tightly fixed.
Always wear protective clothing, glove and safety glasses. It’s forbidden to use the
machine bare-footed or when wearing a sandal.
By operation keep the hand away from the water jet and hose.
Sometimes the reflected water is also dangerous.
Do not direct the water to fire or hot equipment. Hot particles and steam are dangerous.
Do not use the pressure washer with inflammable or toxic liquids, corrosive detergents, or
any dangerous products.
Use only hand to squeeze the trigger, do not jam the trigger in the ON position.
Before disconnect the high pressure hose, turn off the machine first, then squeeze the
trigger until there is no more pressure in the system.
Do not bend, twist or fold the hose.
Use only original spar parts supplied from manufacturer.
A fluctuating or high water pressure shows signal of defect or accumulation of the calcium
in the hose. In this case turn off the machine immediately.
