WWW.YES-RC.COM
10
1. Select this charge process by choosing LiPo CHARGE from the main menu by pressing the
“Start/Enter” button. The display should look similar to this:
LiPo CHARGE
2.0A
11.1V(3S)
When you want to change the values of parameters, please press “Start/Enter” key to make
it blink and then use DES or”INC” to change the value. Then press “Start/Enter” key again to
store the value.
2. The left side of the fi rst line shows the type of battery you choose. The value on the left of
the second line of the charger is current user set, After setting the current and voltage, press
“Start/Enter” key for more than 3 seconds to start the process (charge current: 0.1-5.0A, volt-
age: 1-5V).
3. This displays the number of cells you set up and the processor detects.
S:3SER R:3SER
CONFIRM (ENTER)
Top Line: S = Number of cells selected by you in the previous screen.
R = Number of cells detected by the charger.
If both numbers are identical you can start charging by press “Start/Enter” button. If not, press
“Batt type/Stop” button to go back to previous screen to carefully check the number of cells of
the battery pack before going ahead.
4. This screen shows the real-time status during charge process. Press “Batt type/Stop” key
once to stop the charge process.
Li3s
1.2A 12.59V
BAL
022:43 00682
Number of cells
Battery voltage
Charging time
Charged capacity
Charging current
Charging lithium battery in the balance mode
• This function is for balancing the voltage of Lithium-polymer battery cells while charging. In the
balance mode, the battery needs to have a balance lead to connect to the individual port at
the right side of the charger. And you need to connect the battery’s output plug to the output
of charger.
Charging in this mode is different from the normal modes, because the built-in processor moni-
tors voltage of individual cell and control input current fed into each cell to normalize the voltage.
1. Select this charge process by choosing LiPo BALANCE from the main menu by pressing the
“Start/Enter” button. The display should look similar to this:
