5
After the IP phone is connected to the network
and supplied with power, it automatically begins
the initialization process. After startup, the
phone is ready for use. You can configure the
phone via web user interface or phone user
interface.
Startup
Welcome
I
nitializing... Please wait
It is provided by ITSP for registration (required).
Server Host:
It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).
It is an authenticated ID for authentication provided by ITSP (required).
Display Name:
Line Active: You can select Enabled/Disabled to enable/disable the account.
Register Name:
User Name:
Password:
Label: It is shown on the touch screen to identify the account.
Account Settings:
Click on
Account
->
Register
->
Account X
(X=1,2,3...15,16)
Parameters of the account:
Note: The IP phone also supports IPv6, but IPv6 is disabled by default.
Register Status: It shows the register status of the current account.
It is shown as Caller ID when placing a call.
The wrong network settings may result in inaccessibility of your phone and may have an impact on the
network performance. Contact your system administrator for more information.
Configuring Your Phone
2. Tap
Settings
->
Status
to obtain the IP address of the phone.
3. Open a web browser on your computer, enter the IP address into the address bar
(e.g., "http://192.168.0.10" or "192.168.0.10"), and then press
Enter
.
4. Enter the user name (default: admin) and password (default: admin) in the login page and click
Confirm
.
Network Settings:
Click on
Network
->
Basic
->
IPv4 Config
Static IP Address:
If the phone cannot contact a DHCP server for any reason, you need to
configure IP address, subnet mask, gateway address, primary DNS address
and secondary DNS address for the phone manually.
Accessing the web user interface:
Configuring via web user interface
PPPoE:
If you are using an xDSL modem, you can connect your phone to the Internet via
PPPoE mode. Contact the ITSP for the PPPoE user name and password.
You can configure the network settings in the following ways:
DHCP:
By default, the phone attempts to contact a DHCP server in your network to obtain
its valid network settings, e.g., IP address, subnet mask, gateway address and DNS
address.
1. Swipe down from the top of the screen to enter the control center.
