Gigabit Color IP Phone Using the Advanced Phone Functions
Administrator/User Password
Administrator mode grants unlimited access to the phone configuration on both web
and phone user interface. The administrator/user password is used to access:
Web interface.
The advance settings of the phone such as Network, Account via the Web and
Phone interface.
The default administrator password is
admin
. Meanwhile the user name for Web
interface access is
admin
.
To change the administrator password user can refer to “
SetPassword
”.
Reboot
You should reboot the phone when you are challenged, e.g. after applying changes to
the phone configuration.
To reboot via Web interface:
1)
Choose Phone->Upgrade.
2)
Click Reboot button.
3)
You are prompted to confirm the change, press Yes to confirm the changes, press
No to cancel the operation.
Note:
Any power interruption during the following process will most likely lead to a flash
memory error which will cause system cannot boot up any more.
Reset to Factory
You should reset the phone only in this case: the phone configuration was changed and
the phone is not functioning anymore. To maintain the configuration of the phone, you
need your system administrator or service provider’s advice.
To reset to factory user can refer to “
Reset to factory
”.
Firmware Update
The phone is delivered with pre-installed firmware which allows operating your phone
flawlessly. If you require updating the phone’s firmware please contact your system
administrator. You can only update the firmware via Web interface.
