Yealink CP860 SERIES, Руководство по настройке

Страница: 64 / 77

YealinkCP860 Phones Configuring Guide
56
Files on page 11 .
To configure priority paging group and paging priority enable features via CommPortal
phone configurator:
1.
Click on
Paging Groups->Setting
.
2.
Mark the desired radio box in the
Paging Priority Enable
field.
3.
Select the desired value from the pull-down list of
Priority Paging Group
.
4.
Click
Save changes
to accept the change.
5.
Perform auto provisioning on the phone to download above configurations. For more
information on how to perform auto provisioning, refer to
Downloading Configuration
Files on page 11 .
Note
Using Multicast Paging
To send RTP stream:
1.
Press the multicast paging key when the phone is idle.
The phone sends RTP to a preconfigured multicast address (IP: Port). Any phone in the local
network then listens to the RTP on the preconfigured multicast address (IP: Port). For both
sending and receiving of the multicast RTP, there is no SIP signaling involved.
LED indicators illuminate solid green.
The following figure shows a multicast RTP session on the phone:
2.
Press the
Hold
soft key to place the current multicast RTP session on hold.
3.
Press the
EndCall
soft key to cancel the multicast RTP session.
The priorities of listening addresses are predefined: 1 with the highest priority, 10 with the lowest.
Both the multicast paging sender and receiver’s phones play a warning tone when establishing a
multicast paging call.