YDI EtherLeap, Руководство пользователя

Страница: 9 / 12

EtherLeap User’s Manual
Figure 2.5 – Connecting the Outdoor Figure 2.6 – Plugging the Outdoor
Ethernet Cable to an EtherLeap Ethernet Cable
Plug Round Connector of the
Outdoor Ethernet Cable Here
5. Attach the other end of the outdoor Ethernet cable to the Cat 5 DC Power Injector at port RJ-45
labeled “To ANT.”
6. Connect the Ethernet cable labeled “To PC or ROUTER” from the Cat 5 DC Power Injector to your
computer or PC. If you connect to a router, switch or hub, make sure you plug the cable into the
Uplink/WAN port, otherwise a cross-over cable or adapter will be needed.
7. Install a #6 AWG insulated ground cable (not provided) to the ground connector on the back of the
radio as shown in Figure 2.7. Use an M5 x 12L thread-forming screw, and an M5 flat washer and lock
washer to fasten the earth lug. Torque to 5.7 N-m (4.2 lb-ft). This provides maximum protection
against lightning.
8. Plug the AC Adapter into an AC outlet and connect it to the “DC Power” jack on the Cat 5 DC Power
Injector.
9. Perform antenna alignment procedures at both sites. Proper antenna alignment is crucial for the
correct operation of the EtherLeap system and should only be accomplished by experienced
professionals. After that your installation is complete.
Figure 2.7 – Detail Showing Ground Cable Connection
(this provides maximum lightning protection)
Version 1.0 Page 6 May 2003