YATO YT-99500, Оригинальное руководство пользователя

Страница: 11 / 72

11
EN
O R I G I N A L I N S T R U C T I O N S
the device. During operation, the power cord must always be fully extended and the position
of the power cord must be set so that it does not become an obstacle during product oper-
ation. The power cord should not be placed in a manner that would pose a risk of tripping.
The power supply socket should be located in a place where it is always possible to quickly
remove the product power cord plug. Always pull the power cord by the plug housing when
unplugging it, never by the cord.
If the power cord or the plug is damaged, immediately disconnect it from the supply network
and contact an authorised service centre of the manufacturer for replacement. Do not re-
place the power cord by yourself. Do not use the product with a damaged power cord or plug.
The power cord or plug cannot be repaired and must be replaced with a new one that is free
of defects if these components are damaged.
Instructions for use
The device should not be used in potentially fl ammable or explosive atmospheres, or in
highly dusty and humid environments. Do not use the device in rooms where fl ammable
materials are present. Do not use the device in rooms where animals are present.
Never cover the device. The device heats up to a high temperature and can ignite the mate-
rial with which it has been covered.
The heater must not be located directly under the power supply socket.
Do not use the heater with a programmer, timer, separate remote control system or any other
device which will switch start the heater on automatically due to the risk of fi re if the heater is
covered or incorrectly positioned.
Portable heaters must not be used in the immediate vicinity of bathing area, shower or swim-
ming pool.
Warning! The heater is not equipped with a device which controls the room temperature.
Unless constant supervision is provided, do not use the heater in small rooms where people
are unable to leave the room on their own.
Devices whose protection rating is lower than IPX4 may not be installed in such a manner
that their switch is within reach of persons taking a bath or shower.
Devices whose protection rating is lower than IPX4 must not be used outdoors.
Do not expose the heater to direct precipitation.
Devices permanently fi xed to ceilings or walls must not be installed lower than 1.8 m above
the fl oor.
Never touch the heating lamp with an uncovered hand, even when it is cold. Fat particles on
the skin will settle on the lamp which can lead to damage to the lamp.
HEATER OPERATION
YT-99500, YT-99501 heater installation
Warning! Before starting any assembly work, make sure that the device is disconnected from the power supply socket and is
completely cooled down.
The heater should be suspended on a hook fi xed to the ceiling or roof beam. The fi xing point must be able to bear the weight of
the heater. The power supply socket must be positioned in such a manner that the heater’s power supply plug of the heater can
be removed at any time. Use the chain supplied with the heater to suspend the heater. Suspend the heater in such a manner
that its lowest point is at least 1.8 m from the fl oor. There should be at least 1.5 meters distance between the surrounding walls
and the heater.