YATO YG-05250, Руководство пользователя

Страница: 15 / 92

15
O R I G I N A L I N S T R U C T I O N S
GB
Product when stored should be kept indoors, protect it from dust, dirt and moisture. It is recommended to store the product in its
original packaging.
Store the product in its working position. Do not tilt, do not store products in layers. Do not put anything on the product.
Removal of failures
Find below the typical defects, their causes and possible solutions. In case of any doubts, stop using the product, disconnect it
from power supply and contact the authorized service center of the manufacturer.
Failure Possible cause Problem solution
Device does not start
Device was not switched on
Check if the device has been properly connected and switched on using
the switch
Plug or cable were damaged Contact the authorised service
Power failure. Check the power supply
Damage of internal wiring Contact the authorised service
Device starts, but the temperature
is too low / too high
Too much ice on the evaporator Defrost the device
Condenser is locked by dust Contact the authorised service
Improperly closed door Check if the door was closed and its seal is undamaged
Device placed too close to heat source or fl ow of
air around the condenser was disrupted
Change the location of device
Too high ambient temperature Increase effi ciency of ventilation or displace the device to cooler location
Improper foodstuff s placed in refrigeration
chamber
Remove excessively warm food, check if the food does not block the fans
Device overloaded Reduce quantity of foodstuff s inside the device.
Water leaks from the device
Device was not levelled Level the device
Drainage outlet was blocked Clean the outlet
Disrupted water outfl ow Clean the fl oor of the device
Damaged water container Contact the authorised service
Water container overfl own Empty the water container
Device is excessively loud
Loosen screws or nuts Check and tighten screws and nuts
Device has not been levelled or it stands
unstably
Check the position of the product and change it if necessary.
TECHNICAL DATA
Parameter Measuring unit Value
Catalogue number YG-05250 YG-05251 YG-05255 YG-05256 YG-05260 YG-05262 YG-05270
Rated voltage [V~] 220-240 220-240 220-240 220-240 220-240 220-240 220-240
Rated frequency [Hz] 50 50 50 50 50 50 50
Rated current [A] 2 4 2 4 1.2 1.2 1.2
Rated power [W] 215 520 230 560 170 170 170
Insulation class I I I I I I I
Climatic class 4 4 4 4 4 4 4
LED lamp power [W] - - - - - - -
Operating temperature [
O
C] -2/+8 -18/-22 -2/+8 -18/-22 +2 / +8 +2 / +8 +2 / +8
Rated capacity [l] 282 282 417 417 240 240 240
Coolant (type / weight) R290 70g R290 95g R290 70g R290 95g R600A 65g R600A 65g R600A 65g
Insulation foaming agent C5H10 C5H10 C5H10 C5H10 C5H10 C5H10 C5H10
Net weight [kg] 102 110 134 159 76 70 75
Noise level
- acoustic pressure LpA ± K [dI(A)] < 70 < 70 < 70 < 70 < 70 < 70 < 70
- power LwA ± K [dI(A)] < 80 < 80 < 80 < 80 < 80 < 80 < 80
Max. load on shelves / containers GN [kg] 40 40 40 40 40 40 40
Parameter Measuring unit Value
Catalogue number YG-05275 YG-05280 YG-05290 YG-05300 YG-05305 YG-05310
Rated voltage [V~] 220-240 220-240 220-240 220-240 220-240 220-240
Rated frequency [Hz] 50 50 50 50 50 50
Rated current [A] 1.2 1.2 1.6 1.6 1.6/0.8 2