YASKAWA Motoman SV3X, Системное руководство

Страница: 33 / 46

INSTALLATION
MOTO MAN 4-5 Arc-WorldLite 50 System Manual
WARNING!
• If proper earth grounds cannot be provided, do not use the
equipment! Serious injury or death can occur.
• Do not place the MIG system within 50 feet of other sources of
noise (i.e., GTAW arc starters, plasma cutters, induction
furnaces, high-power-resistance spot welders, dielectric
heaters, etc.). Equipment that generates impulse or high-
frequency noise can cause unexpected equipment operation and
failure, which can result in serious injury or death.
NOTE: If the robot and the XRC are within 15 feet of each other, a common earth ground may be used.
Otherwise, separate earth grounds must be used.
1. Connect one end of robot earth ground cable to lug marked EARTH
GROUND on bottom back of robot.
2. Connect other end of robot earth ground cable to earth ground stake.
3. Connect one end of second earth ground cable to common ground bus bar
inside XRC.
4. Connect other end of second earth ground cable to earth ground stake.
4.5.2 Connecting the Water Circulator (Optional)
If your system uses the water cooled welding torch, it is necessary to connect the
Motoman water circulator. To connect the water circulator, proceed as follows:
1. Connect two water hoses form weld torch to connections on water circulator
marked WATER-IN and WATER-OUT (see Figure 4-5).
CAUTION!
• Use only the antifreeze provided by Motoman. Automotive
antifreeze contains stop-leak additives that will clog small torch
water-cooling ports and damage gaskets in pump.
• Do not fill water circulator past fill line. Damage to water
circulator could occur.
2. Fill water circulator tank with antifreeze coolant provided (P/N 131224-1).
Do not fill water circulator past fill line.
3. Plug power cable into electrical outlet on back of power source, or the 110
Volt AC (10 Amp.) outlet.