Page 5
The Communication Board of Inverter
RS485 Port
1
Inverter Wire-Box
Remove the (3) screws that attach
the inverter communication board
in the Wire-Box using a #2 Phillips
bit.
2
Replace the screws with the (3)
standoffs included in the ENC Kit.
6-PIN Header
6-PIN Connector
3
Install the ENC by carefully aligning
the 6-PIN connector in the upper
left-hand corner of the communication
board.
Install the (3) screws into the stand-
offs to secure the ENC in place.
Install the 3 screws and torque to 7
in-lbs using a #2 Phillips bit.
