
FINAL ASSEMBLY AND
ADJUSTMENTS
•
Insert the (optional) remote chute ca-
bles into the cable control wire, located
on top of the engine. See Figure 15.
•
The space between the shave plate and
the ground can be adjusted. For close
snow removal, place slide shoes in the
low position. Use middle or high posi-
tion when area to be cleared is uneven.
See Figure 16.
NOTE:
Some models are equipped
with reversible slide shoes as
shown in Figure 17.
Adjust slide shoes by loosening the hex
nuts, washers (if equipped) and car-
riage bolts and moving slide shoes to
desired position. Make certain the entire
bottom surface of slide shoe is against
the ground to avoid uneven wear on
the slide shoes. Tighten bolts securely.
CHUTE CLEAN-OUT TOOL
The chute clean-out tool is conveniently
fastened to the rear of the auger hous-
ing with a mounting clip. Use the
clean-out tool to clear snow and ice
which may lodge in the discharge chute
during operation. Refer to the Operation
section for more detailed information re-
garding the chute clean-out tool.
BEFORE STARTING
NOTE:
The crankcase has been
filled with oil and factory tested.
Paint on the muffler may have burnt
due to testing.
Your unit may be equipped with a
white plastic fuel plug at the opening
of the fuel tank. Please remove and
discard the plug before filling your
unit with gas or before putting the
unit into operation.
Failure to follow this procedure may re-
sult in serious engine damage which
will not be covered by warranty.
GAS AND OIL FILL-UP
Service the engine with gasoline and oil
as instructed in the separate engine
manual packed with your snowthrower.
Read instructions carefully.
WARNING: Never fill fuel tank
indoors. Never fill fuel tank with
engine running or while engine
is hot. Do not smoke when fill-
ing fuel tank.
10
FIGURE 16 - STANDARD SLIDE SHOE
Slide Shoe
Hex Nuts
Carriage Bolts
FIGURE 15
Cable Control
Wire
ATTENTION: YOU MUST CHECK OIL
LEVEL BEFORE OPERATION. LEVEL
MUST BE AT FULL MARK ON DIPSTICK
BEFORE ENGINE IS STARTED.
FIGURE 17 - REVERSIBLE SLIDE SHOE
Hex Nut
Flat Washer
Reversible
Slide Shoe
Cupped
Washer