model no.
055-0361-0
| contact us: 1.866.523.5218
model no.
055-0361-0
| contact us: 1.866.523.5218
7
ADD ENGINE OIL
The recommended oil type is 10W-30 automotive oil.
1. Place the generator on a flat, level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Add up to 0.6 qt (0.6 L) of oil and replace oil fill cap/dipstick. DO NOT OVERFILL.
4. Check engine oil level daily and add as needed.
Once oil has been added, a visual check should show oil about 1–2 threads from running
out of the fill hole.
If using the dipstick to check oil level, DO NOT screw in the dipstick while checking.
The engine is equipped with a low oil shut-off and will stop when the oil level in the
crankcase falls below the threshold level.
We consider the first 5 hours of run time to be the break-in period for the unit. During
the break–in period stay at or below 50% of the running watt rating and vary the load
occasionally to allow stator windings to heat and cool. Adjusting the load will also cause
engine speed to vary and help seat piston rings. After the 5 hour break-in period, change
the oil.
Weather will affect engine oil and engine performance. Change the type of engine oil used
based on weather conditions to suit the engine needs.
Synthetic oil may be used after the 5 hour initial break-in period. Using synthetic oil
does not increase the recommended oil change interval.
!
WARNING: DO NOT attempt to crank or start the engine
before it has been properly filled with the recommended
type and amount of oil. Damage to the generator as a result
of failure to follow these instructions will void your warranty.
!
IMPORTANT: The generator rotor has a sealed, pre-
lubricated ball bearing that requires no additional
lubrication for the life of the bearing.
Full Synthetic 5W-30
Degrees Celsius (Outside)
(Outside)
Degrees Fahrenheit
A
ssembl
y
