1. Use a plier to pull down the spring pin and insert the slide-
rail through the fixed guide rail until the two bolt holes on the
slide-rail are fully exposed. (See
Figure 5a
)
2. Insert the bending plate into the U-shaped narrow slot of the
slide-rail, align the two holes on the bending plate with the
two holes on the slide-rail, and then tighten them with M8x16
bolts. (See
Figure 5b
)
M8 X 16
X 2
3
Figure 5a
Figure 5b
Slide-rail
Fixed Guide Rail
Bolt Holes
Spring Pin
Bending Plate
M8x16
(x2)
Slide-rail
1
2
Slide-rail
Fixed Guide Rail
Bolt Holes
Spring Pin
Bending Plate
M8x16
(x2)
Slide-rail
1
2
6
mm
8
mm
5
mm
10
mm
Slide-rail Assembly
Connecting Plate Assembly
Main Table & Side Table Assembly
1. Assemble the side table and the main table together to ensure
that the hole positions at the connection are aligned. (See
Figure 7a
, illustration 1)
2. Use a D type pin to insert the right connection hole between
the main table and the side table. (See
Figure 7b
, illustration 2)
3. Align the front hole of the left support leg with the left
connecting hole between the main table and the side table,
and fix them with a D type pin. At the same time, align the rear
hole of the left leg with the left hole at the bottom of the main
table and then fasten with M10x60 long bolts, washers and
nuts. (See
Figure 7b
, illustration 3)
Figure 7a
1. Assemble the connecting plate onto the tank, taking care to
ensure the correct bending direction of the plate. (See
Figure
6
)
M10 X 20
X 4
4
Figure 6
Connecting Plate
M10x20
(x4)
13
mm
10
mm
16
mm
19
mm
Main Table
Side Table
1
Left Support Leg
M10x60
(x1)
3
2
M10x60
(x2)
Right Support Leg
4
D type pin 9.3x70
(x2)
6
Log lift table attachment
»
Operator’s Manual
Assembly
|
