ASSEMBLY
To assemble your log lift table attachment follow the below instructions.
Preparation
1. Remove the right log cradle before assembling the log lift table
attachment. ( See
Figure 1a
)
Figure 1a
M10x25
(x4)
Log Cradle (Right)
13
mm
10
mm
16
mm
19
mm
2. Start the engine and operate the control handle to make the
wedge move forward 8''. (See
Figure 1b
)
3. Switch off the engine. Make sure the wedge is no longer moving.
Figure 1b
Split Control Handle
Wedge
1. Remove the two sets of hexagon recessed head screw M12x55
that fix the guide slide plate with the wedge. (See
Figure 2a
)
2. Align the holes on the U-shaped plate at the front end of the
ejector rod with the holes on the wedge plate and guide slide
plate, then fasten them using M12X65 bolts and nuts. (See
Figure 2b
)
M12 X 65
X 2
1
Figure 2a
Figure 2b
M12x65
(x2)
M12x55
(x2)
Ejector Rod
M12x65
(x2)
M12x55
(x2)
Ejector Rod
16
mm
13
mm
10
mm
18
mm
19
mm
24
mm
32
mm
13
mm
10
mm
16
mm
19
mm
13
mm
10
mm
16
mm
19
mm
6
mm
8
mm
5
mm
10
mm
Ejector Rod Assembly
4
Log lift table attachment
»
Operator’s Manual
Assembly
|
