YARDMAX YS0952, Руководство оператора

Страница: 9 / 20

YS0952PM00 - 2002
ADJUSTING THE RETURN STOP
LOADING A LOG
If you are having trouble splitting a very hard piece of wood,
simply rotate your log 90° and try splitting it from that direction.
If the log cannot be split, then its hardness exceeds the machine's
capacity.
Do not split logs on the upper part of the blade.
This could break the blade or damage the
machine.
SPLIT HARD WOOD
2-STAGE CONTROL
When loading a log, place hands on the sides of the log, not the
ends. Make sure logs will not twist, rock, or slip while being split.
If you are splitting a pile of shorter logs, you may want to prevent
the pusher plate returning all the way back to start, as this will
speed up future operations.
To adjust the pusher plate position:
1. Extend the ram fully. When the ram is at full extension, release
the push button switch, but keep the control lever pressed
down to prevent the ram from returning.
Do not put any logs on the log splitter at this stage.
2. Loosen the handwheel on the return stop.
3. Slide the stop to the desired position, moving the stop toward
the splitter to shorten the stroke.
4. Tighten the handwheel on the return stop to lock it into
positon.
5. Make sure your hands are clear of the ram, and release the
control lever.
The ram should return as far as the stop will allow.
1 2
3 4
The splitting force and speed are governed by the 2-stage control
lever. Push the lever to POSITION 1 to advance (faster) to the log
using less splitting force.
Don’t split the logs at POSITION 1. Push
the lever all the way to POSITION 2 to apply maximum splitting
force and slower speed to split logs. These stages can be changed
simply by moving the lever to one position or the other.
SPLIT LOG
POSITION 1 POSITION 2
ADVANCE to LOG
8
Electric Log Splitter
»
Operator’s Manual
Operation
|