Page | 8
NATURAL GAS INSTALLATION AND SETUP
Turn on the gas supply, ignite the burner, and
test at all connections for leaks using a spray
bottle and soapy water solution. Spray
around the entire circumference of each metal
fitting. If bubbles appear, a leak is present.
Turn off the gas and tighten at all
connections. Repeat until no leaks are
present. If a leak persists, turn off the gas
supply and contact your local gas company
or the Yardbird Customer Experience Team.
NEVER USE A FLAME TO CHECK FOR LEAKS
Before operating the appliance, conduct
a leak test on all hose and fitting connections
to ensure the appliance is safe to use
Leak Test
Coupler
Brass Insert
Propane Gas
Brass Insert
Natural Gas
Brass Insert
Coupler Fitting
Air Mixer
Stainless Steel Hose
*The gas hose connector shall have a connector that complies with the Standard for Gas Hose
Connectors for Portable Outdoor Gas-Fired Appliances, ANSI Z21.54 CSA 8.4.
3.
Disconnect the stainless steel spiral hose from
the LP coupler fitting attached to the air mixer.
Then, remove the coupler from the air mixer
assembly.
Remove the brass insert from the coupler and
replace it with the provided natural gas brass
insert.
Note: the LP brass insert has a smaller
orifice than the natural gas brass insert.
4.
Slide the provided air shutter over the air mixer
tube so that it blocks off the air holes. Reinstall
the coupler with the new natural gas insert.
Then, re-attach the stainless steel spiral hose
to the coupler.
6.
Air Mixer
Stainless Steel Hose
Coupler Fitting
Air Shutter
5.
