3.
CHECK THE GAS TYPE
(natural gas or propane): The gas supply you intend to use
may not be the same as that stated on the unit rating plate as purchased. If the gas
supply is different, convert the unit to the gas type you intend to use. See the natural
gas installation and setup instructions on pages 7 and 8. If you are unsure, contact a
professional for assistance.
4.
FOR NATURAL GAS
: The minimum inlet gas-supply pressure for purposes of input adjustment is
3.5 "water column (w.c.), and the maximum inlet gas-supply pressure is 10.5 " w.c.
5.
FOR PROPANE:
The minimum inlet gas-supply pressure for purposes of input adjustment is 8"
w.c., and the maximum inlet gas-supply pressure is 13" w.c..
Do not install this appliance if the inlet
pressure is below the stated minimum or exceeding the stated maximum pressure.
6. For installations at elevations above 2,000 ft., contact your local dealer or gas supplier before
installing. Input ratings should be reduced approximately 4% for each 1,000 ft. above sea level.
Refer to the National Fuel Gas Code for more information.
7. The appliance and it’s control valve must be disconnected from the gas-supply piping system
during any pressure testing of that system at test pressures in excess of 1/2 psi (3.5 kPa). The unit
must be isolated from the gas-supply piping system by closing its manual control valve during any
pressure testing of the gas-supply piping system at test pressures equal to or less than 1/2 psi (3.5
kPa).
8.
This appliance should be installed so that it can be removed if service is required.
9.
NATURAL GAS PLUMBING REQUIREMENTS:
Apply only joint compounds that are resistant to all
gases on all male pipe fittings. Make sure to tighten every joint securely. Do not use pipe joint
compound to connect
fl
are fittings. Bring the gas-supply pipe up from beneath the enclosure near its
center (if applicable).
Page | 5
TOOLS AND SUPPLIES REQUIRED FOR LP SET UP AND INSTALLATION
PRIOR TO INSTALLATION
PRE-INSTALLATION AND PREPARATION SAFETY GUIDELINES
- Work Gloves
- Safety Glasses
- Utility Knife (for unboxing)
- Adjustable Wrenches x2
- Phillips Screwdriver
- 4mm Hex Wrench (for Eden fire tables ONLY)
- AAA Battery
-Spray Bottle (filled with soapy water)
1.
Carefully inspect the appliance for any damage that occurred during transit. If any parts
are damaged, refer to the replacement part list on page 11 and call the Yardbird Customer
Experience Team at 877-927-2846 or [email protected]
2. Before proceeding, carefully read this manual in its entirety to ensure that you are in compliance with
all safety precautions and warnings while installing this appliance.
