Yard-Man 31AE633E401, Руководство оператора

Страница: 6 / 28

6
• Secure the upper handle and lower handle with the
two plastic wing nuts, cupped washers and carriage
bolts previously removed. Attach these hardware
on the lower hole in the handles. See Figure 3.
NOTE: On model 633E, attach the wing nut, cupped
washer and carriage bolt in the lower hole on the right
side only. The hardware in the left lower hole will be
attached later.
• Tighten the two wing nuts already in place on the
upper holes and secure the handles firmly. See
Figure 3.
• Slide the shift rod connector down over the end of
the lower shift rod. See Figure 4. Tap the connector
until it locks on the lower shift rod.
NOTE: If the connector is not properly assembled, the
shift rod will pivot and you will not be able to change
direction or speed of the snow thrower.
Figure 4
• If not already attached, slip the cables that run from
the handle panel to the chute into the cable guide
located on top of the engine. See Figure 5.
Figure 5
• Unwrap the headlight wire which is attached to the
headlight beneath the handle panel. Wind the
headlight wire around the right side of the lower
handle until excess slack is removed. See Figure 6.
• Plug the wire from the headlight into the alternator
lead coming from the right side of the engine,
underneath the fuel tank. See Figure 6 inset.
Figure 6
Attaching Chute Directional Control
Model E633E
• Remove the wing nut and cupped washer from the
eyebolt on the chute directional control. Leave the
hex nut in place on the eyebolt (the nut must be
threaded at least halfway onto the eyebolt).
• Insert the eyebolt through the lower hole on the left
side of handle. Secure with cupped washer
(cupped side against the handle panel) and wing
nut. See Figure 7. Do not tighten at this time.
Figure 7
• Adjust the chute directional control support bracket
so that the spiral on the chute directional control
fully engages the teeth on the chute assembly.
• Tighten wing nut with eye bolt to secure chute
directional control.
Note: Cut-out view of lower handle shown for clarity.
Connector
Lower
Shift Rod
Upper Shift
Rod
Cable Guide
Lower Handle
Alternator
Lead
Lamp
Wire
Eye Bolt
Wing
Nut
Cupped
Washer