Yanmar CANplus 600, Операция и устранение неисправностей, Страница: 8 / 40

Yanmar
®
600 Control Panel Operation and Troubleshooting
8 463-3000-09 Initial - 16-May-2008
Active Alarms
A flashing popup window is overlaid on the current screen when an active alarm is received. The popup
includes a plain language description in addition to the standard SPN/FMI (Suspect Parameter
Number/Failure Mode Indicator) pair defined by the SAE J1939 standard. Additionally, if enabled, the
beeper sounds as an audible cue.
Example alarm message, alarm list screens showing
unacknowledged conditions and acknowledged alarms.
After acknowledgement, the exit button becomes active.
Note
Standard J1939 abbreviations are used for alarms.
MS
= Most Severe,
MOD
= Moderately Severe,
LS
= Least Severe.
Alarm List
The Alarm List is accessed by pressing any button while an alarm popup is displayed or by pressing any of
the first 4 buttons to show the button bar and then button 4
. Alarms not yet acknowledged are shown in
grey on black while acknowledged alarms are shown in black on grey. The list also indicates when the alarm
occurred if engine hours are available. The most recent alarm is displayed at the top of the list. The list can
be scrolled using buttons 1
and 2 and alarms acknowledged by pressing button 3 . The Alarm
List can be closed by pressing Button 5 once the alarms are acknowledged.
An alarm indicator is displayed near the upper right corner of the display as long as alarms are active.
The indicator and alarm messages in the list are automatically removed when the alarm is no longer
received for a few seconds.
Note
Only active faults are displayed in the alarm list.
Once a fault is corrected it is automatically removed from the list.
To view previously active faults use the engine diagnostic tool.