Yanmar 6SY Series, Руководство по эксплуатации

Страница: 91 / 128

PERIODIC MAINTENANCE
6SY Operation Manual
83
11.Perform a trial run and check for oil
leaks.
12.Approximately 10 minutes after
stopping the engine, remove the oil
dipstick and check the oil level. Add oil
if the level is too low.
Clean the Centrifugal Engine Oil
Cleaner
Clean the centrifugal engine oil cleaner
every time the oil is changed.
1. Clean the oil cleaner cover. Turn the nut
counterclockwise to remove. Carefully
remove the cover in case the oil is hot.
2. Lift out the rotor and turn the nut on the
rotor bowl counterclockwise three turns
(Figure 2) .
Figure 2
• If the nut is jammed, clamp the nut in a
vise and turn the rotor three turns
counterclockwise by hand or with a
wrench
(Figure 3) .
IMPORTANT
NEVER clamp the rotor in a vise.
NEVER strike the rotor bowl.
Doing so may cause damage
resulting in imbalance.
Figure 3
CAUTION
• NEVER overfill the engine with
engine oil.
• ALWAYS keep the oil level
between upper and lower lines
on the oil cap / dipstick.
0000015en
A
WARNING
BURN HAZARD!
• If you must drain the engine oil
while it is still hot, stay clear of
the hot engine oil to avoid
being burned.
• ALWAYS wear eye protection.
• Failure to comply could result
in death or serious injury.
0000011en
0002 3 76