SHUTTING DOWN THE
ENGINE
NOTICE: Do not stop engine abruptly
during operation. Yanmar recommends
that when shutting the engine down,
allow the engine to run, without load, for
5 minutes. This will allow the engine
components that operate at high
temperatures, such as the exhaust
system, to cool slightly before the
engine itself is shut down.
1. Reduce engine speed to low idle and
put remote control handle in
NEUTRAL.
2. Accelerate from low speed to high
speed and repeat five times. This will
clean out the carbon from the cylinders
and the fuel injection nozzles.
(1)
(2)
(3)
(4)
(5)
0004890
Figure 7
3. Allow engine to run at low speed
(approximately 1000 rpm) without load
for 5 minutes.
4. With the key in the ON position, push
and hold the stop button
(Figure 7, (1)) until the engine is off.
Note: Continue to hold the stop
button in until the engine is
completely stopped. If the button is
released before the engine has
completely stopped, it may restart.
5. After the engine has stopped, turn the
key switch to OFF (Figure 7, (4)).
Note: If the engine does not shut
off when the engine stop button is
pushed, close the fuel cock on the
fuel tank.
6. Remove the key.
7. Turn off the battery master switch (if
equipped).
8. Close the fuel cock.
9. Close the seacock (if equipped).
NOTICE: Be sure to close the
seacock. Neglecting to close the
seacock could allow water to leak
into the boat and may cause it to
sink.
ENGINE OPERATION
46
6LPA Series Operation Manual
© 2007 Yanmar Marine International
Содержание 6LPA-STP2
