EN46275900 Replacement Motor
Description:
The EN46275900 is a sealed bearing
aftermarket replacement motor for Field
Controls
SWGII-4HD, SWG-4HD AND SWG-
4HDS (SWG-4HDRMK, SWG-4RMK) Side Wall
Venters.
EN46275900
Includes:
1 pc – 1/20HP 115V. 3000RPM Motor
1 pc – 3oz High Temp Silicon
4 pcs – 8-32 Lock Nut
4 pcs – Wire nuts
Warning:
For your protection, read and follow these
instructions carefully before installing the motor.
These instructions do not attempt to cover all
installation and situations. If you do not understand
these instructions or additional information is
required, contact Endeavoring Enterprises.
The
EN46275900 must be installed by a qualified
technician familiar with the local codes,
construction and operation of this type of product.
To avoid electric shock,
serious injury, or death, be
certain that all electrical power is disconnected
before installing or servicing your
power venter.
Installation:
1. Shut off power to side wall venter and
make sure unit is cool enough to
operate on.
2. Remove the screws from
motor enclosure assembly
to access the motor
compartment.
3. Remove motor
electrical box cover and
separate the wires.
Remove electrical
conduit assembly from
the old motor.
4. Remove the nuts
that secure the fan
and motor assembly
to the SWG housing.
Carefully remove the
motor and fan
assembly from the
SWG housing.
5. Insert 1/8” Allen key
into the blower wheel
and remove the blower
wheel and the flat plate
below the fan from the
motor assembly.
6. Insert a 5/64” Allen key
into the heat slinger and
remove the heat slinger
from the motor assembly.
7. Take off the lock nuts from
the motor base plate and
remove the motor base
plate.
8. Clean off any debris that
has built up on the blower wheel.
INSTALLATION GUIDE
