Yanmar 3TNV82A-B, Руководство по обслуживанию

Страница: 117 / 394

PERIODIC MAINTENANCE
TNV DI Service Manual 5-27
Periodic Maintenance Procedures
• When the amount of fluid nears the lower limit
(Figure 5-8, (1)), fill with distilled water
(Figure 5-8, (2)) so it is at the upper limit
(Figure 5-8, (3)). If operation continues with
insufficient battery fluid, the battery life is
shortened, and the battery may overheat and
explode. During the summer, check the fluid
level more often than specified.
Figure 5-8
• If the engine cranking speed is so slow that the
engine does not start, recharge the battery.
• If the engine still will not start after charging,
have your authorized Yanmar industrial engine
dealer or distributor check the battery and the
engine’s starting system.
• If operating the machine where the ambient
temperature could drop to 5°F (-15°C) or less,
remove the battery from the machine at the end
of the day. Store the battery in a warm place
until the next use. This will help start the engine
easily at low ambient temperatures.
Perform the following maintenance every 250 hours
of operation.
• Drain Fuel Tank
• Replace Engine Oil and Engine Oil Filter
• Check and Clean Radiator Fins
• Check and Adjust Cooling Fan V-Belt
• Check and Adjust the Governor Lever and
Engine Speed Control
• Clean Air Cleaner Element
Drain Fuel Tank
0000067A
(3)
(1)
(2)
Every 250 Hours of Operation
A
DANGER
FIRE AND EXPLOSION HAZARD!
• Diesel fuel is flammable and explosive
under certain conditions.
• When you remove any fuel system
component to perform maintenance
(such as changing the fuel filter) place
an approved container under the
opening to catch the fuel.
• NEVER use a shop rag to catch the
fuel. Vapors from the rag are
flammable and explosive.
• Wipe up any spills immediately.
• Wear eye protection. The fuel system
is under pressure and fuel could spray
out when you remove any fuel system
component.
• Failure to comply will result in death or
serious injury.
0000009en
TNV_DI_SM_A4.book 27 ページ ２００７年１２月６日 木曜日 午前９時２３分