Yanmar 2TNV70, Руководство по эксплуатации

Страница: 87 / 142

PERIODIC MAINTENANCE
TNV Operation Manual 69
CAUTION
0000011en
New Engine Break In:
• On the initial engine start-up, allow the
engine to idle for approximately 15
minutes while you check for proper
engine oil pressure, diesel fuel leaks,
engine oil leaks, coolant leaks, and for
proper operation of the indicators
and / or gauges.
• During the first hour of operation, vary
the engine speed and load on the
engine. Short periods of maximum
engine speed and load are desirable.
Avoid prolonged operation at
minimum or maximum engine speeds
and loads for the next 4 to 5 hours.
• During the break-in period, carefully
observe the engine oil pressure and
engine temperature.
• During the break-in period, check the
engine oil and coolant levels
frequently.
CAUTION
0000012en
NEVER engage the starter motor while
the engine is running. This may damage
the starter motor pinion and / or ring
gear.
CAUTION
0000013en
Be responsible to the environment.
Follow these procedures for hazardous
waste disposal. Failure to follow these
procedures may seriously harm the
environment.
• Follow the guidelines of the EPA or
other governmental agency for the
proper disposal of hazardous
materials such as engine oil, diesel
fuel and engine coolant. Consult the
local authorities or reclamation facility.
• NEVER dispose of hazardous
materials irresponsibly by dumping
them into a sewer, on the ground or
into ground water or waterways.
CAUTION
0000014en
Protect the air cleaner, turbocharger (if
equipped) and electric components
from damage when you use steam or
use high-pressure water to clean the
engine.
CAUTION
0000015en
• NEVER overfill the engine with engine
oil.
• ALWAYS keep the oil level between
upper and lower lines on the dipstick.
CAUTION
0000016en
NEVER use high pressure water or
compressed air at greater than 28 psi or
a wire brush to clean the radiator fins.
Radiator fins damage easily.