YANGZI YZ-X8, Инструкция по эксплуатации

Страница: 10 / 18

8
The machine installation
Install suction harrow assembly
1.
Park the machine on the level ground and take out the key.
2.
Lower the suction lift lever to the lower position.
As shown in the figure, install the water absorption gripper to the water absorption
gripper mounting bracket. Make sure to place the fastening knob into the jack
completely before tightening the knob
4. Connect vacuum suction hose to suction scraper assembly.
5. Check water absorption strip and make appropriate adjustment
Install brush and clean pad
Note:Pleaserefertothe"InformationonBrushesandMATS"section ofthis
manual,orcontactyourlocalauthorizeddealerformoreinformation.
1. Place the machine on the level floor and take out the key.
Step on the lift pedal of the brush head to lift the brush head off the ground
3. Putthebaiqingpadontheneedleseatbeforeinstallingthedriveplate.
Fasten the central lock to secure the clean pad.
4. Align the pin holder/brush mounting pin into the motor drive disc clasp and press
the brush disc motor switch.
5. To remove the pin base and brush, step on the lifting pedal of the brush head to lift
the brush head off the ground and press the motor switch of the brush plate.
Machine operation
Forsafety:Donotoperatethemachineuntilyouhavereadandunderstoodthe
operation manual.
Warning: Do not operate near or in areas with flammable liquids, gases or dust.
Pre-operation inspection
Dust the ground with your mouth.
Check the power scale of the battery.
(Refer to battery meter)
Check the wear of the pads/brushes.
Check the wear condition of the suction strip and adjust the Angle appropriately.
Make sure the tank is empty and a clean floating screen has been installed.