6
Before Using This Unit
Requirements for Installation
3. Before/after installing
•
It may cause injure to a person if this unit falls down or moves by the earthquake and the
impact. etc..To prevent, take measures that the unit cannot fall down, and not install to busy
place.
4. Ventilate the equipment sufficiently
•
Do not block the heat releasing outlets on the side face and back face of equipment during
operation. The temperature inside the equipment rises, which may cause the deterioration or
failure of equipment, accident, or fire disaster.
5. Do not use this unit in an area where there is flammable or explosive gas
•
Never use this unit in an area where there is flammable or explosive gas. This unit is not
explosion-proof. An arc may be generated when the power switch is turned ON or OFF, and
fire/explosion may result.
•
To know about flammable or explosive gas, refer to page 24 “List of Dangerous Substances”.
6. Choose a correct power distribution board or receptacle
•
Choose a correct power distribution board or receptacle that meets the unit’s rated electric
capacity.
•
Operating voltage range for respective equipment models are as follows.
models: AC100 to 120V SK110C models: AC200 to 240V
Electric capacity:
SK100C: AC100V-120V 9A-12A, SK110C: AC200V-240V 4.5A-6A
NOTE)
There could be the case that the unit does not run even after turning ON the power. Inspect
whether the voltage of the main power is lowered than the specified value, or whether other
device(s) uses the same power line of this unit. If the phenomena might be found, change the
power line of this unit to the other power line.
•
Starburst connection with a branching receptacle or extended wiring with a cord reel lowers
electrical power voltage, which may cause the degradation of refrigeration capability.
•
Connect the unit to only the power supply. If it is connected to a gas pipe, water pipe or
telephone line, an accident or malfunction may result.
