YCO-1047-03-13
PPC-200(W)
Operation Manual
Remove everything from the platform surface and press the
key. The display will briefly flash all the LCDs. After approxi
-
mately 5 seconds, the display will stop flashing and automati
-
cally set to zero.
III Directions for Use
III.A Installing Batteries or AC adaptor
Remove the stainless steel platform. Gently and carefully turn the scale on it's side. Ensure the surface
around the battery cover is dry. Do not allow water to enter the battery compartment. Turn the bat-
tery cover thumbscrew counterclockwise until it comes free. Swing the cover open. Install the bat-
teries according to the polarity markings. If you reverse the polarities of the batteries, the scale will
be damaged. Swing the battery cover into place and insert the thumbscrew. Tighten the thumbsrew
securely. If the battery cover is loose, the washdown seal will leak.
Use only the AC adaptor specified for use with the scale. Using the wrong adaptor can damage the
scale. Remove the battery cover and the batteries, if installed. Replace the battery cover. Remove
the washdown plug from the jack. Insert the adaptor plug securely into the jack. Do not washdown
the scale if an AC adaptor is in use or if the washdown plug has been removed from the AC jack.
III.B Leveling the Scale
Place the scale on a flat and level surface. If the scale is not level, the readings may
not be accurate. You can check whether the scale is level by using the bubble
level device positioned on the left front surface of the scale. Adjust the feet by turn-
ing them in or out to lower or raise the corner of the scale the foot is on.
III.C Turning the Scale On and Off
Press the
key. The display will
go off. Under battery operation, the power will
be shut off auto-
matically (AutoOff function) after about 15 minutes of non-use, even if you don’t press the
key.
2
III.D Checking the Battery Level
Turn the scale on and push the
key while the display is flash
-
ing. The remaining battery life will be displayed. The more “o”
you see, the more life there is left in the batteries. After a few
seconds, the scale will go to weighing mode.
III.E Zero the Display
The scale will zero automatically when turned on. If a value is displayed when the platform is empty,
push the
key to zero the display. The maximum zero range during power up is approximately
± 1.9% of the scale capacity.
III.F Switching Between LB and KG
To switch between LB and KG, press and hold the
key and press the
key.
