Yamarin Cross 62 BR, Руководство пользователя, Страница: 26 / 116

26
NOTE!
If your boat is equipped with a Water skiing bracket (an accessory), please ensure that the
engine will not tilt, with the engine casing hitting the bracket, during transport.
When letting the boat down from the trailer, remember to fasten the bow rope to the boat
beforehand so that you can release the cable from the trailer hook as soon as the boat is in
the water. Be careful with the winch handle!
9.10.7 Docking
The storage cradle should be sufficiently steady and suitable for this particular boat and
engine combination. A sturdy plank (e.g. a 2x4) should be placed between the V trestles to
support the keel and the bear most of the weight of the boat. The boat must not rest on the
side supports. The side supports should not be placed touching the bottom chine, and point
loads should be avoided. The supporting structures should be strong, particularly near the
transom, to support the added weight of the engine.
Only use reputable lifting companies or boat yards with sufficient lifting capacity. In ad -
dition to the boat’s tare weight (please refer to the technical specification), also take into
consideration accessories and other possible loads in the boat.
When the boat is being lifted, the lines must be placed under the boat and the boat must
remain horizontal during lifting.
NOTE! Do not lift the boat by its bollards.
DANGER! Never stand under a boat that is suspended from a crane.
10. Servicing and maintenance
Keep your boat and its equipment clean and tidy. This increases comfort and safety on
board, and also the boat’s resale value.
Familiarise yourself with the service procedures shown in the engine manual (see annex).
Have your engine serviced according to the instructions in the manual.
10.1. Washing and waxing the boat
Cleaning fibreglass surfaces
Normally it is sufficient to just wash and wax the deck. Special boat cleaning agents are
most suitable for the purpose. Do not use strong solvents; they can cause glossy surfaces
to fade. Mildly abrasive polishes can be used to remove chafes and embedded dirt from
the deck. The boat’s aluminium and fibre glass surfaces can be washed with a pressure
washer. Observe the chemical manufacturer’s instructions when washing and cleaning the
deck. The cleaning and maintenance instructions given here apply to Star brite products,
available at well-stocked boating shops.
Useful tip:
Washing the boat will be easier if it is done immediately after getting the boat out of the
water.