Yamarin Cross 46 Side Console, Руководство пользователя

Страница: 23 / 44

23 (44)
5.9.4 Adjusting the trim angle
These are the main rules when adjusting the trim angle:
-
When bringing the boat to plane, keep the ‘bow down’ position.
-
When the boat is planing and seas are calm, keep lifting the bow until you can feel
that both the engine and the boat move very easily. In calm waters, the engine
should normally be trimmed up at least 3 scale marks on the trim indicator on the
revolution counter. If the engine is trimmed up too much, the speed of the boat will
be reduced. If the boat is trimmed too low, the boat will run slowly and the engine
will run heavily. To achieve good fuel economy, it is important to drive the boat with
the right engine trim angle.
-
In heavy head seas, lower the bow to allow it to slice through the waves better, thus
providing a smoother ride.
-
In following seas, raise the bow to avoid ‘diving’ into the waves.
-
When reversing, raise the trim angle slightly to bring the engine up.
WARNING!
Do not drive the boat at high speeds with the engine trimmed up
(bow up), as there is a risk of sudden heeling when the propeller
hits the water again after a flight in heavy waves. Likewise, do not
drive at high speed with the engine completely trimmed down
(bow down) since this can cause the boat to pitch unexpectedly
when the bow hits the water.
WARNING! Waves reduce manoeuvrability and make the boat heel.
Accordingly, reduce speed when encountering heavier seas.
5.9.5 Starting the engine
1. Switch the power on using the main power switch.
2. Lower the engine to the driving position by pressing the Power Trim button on the
gear/throttle handle.
3. Check that the gear/throttle handle is in the neutral position and that the emergency
switch is attached to the bottom of the remote control.
4. Switch on the current, using the start key, without starting the engine and wait a few
seconds for the warning lights to light up.
5. Start the engine by turning the ignition key clockwise until the engine starts. If
everything is in order, the engine should start within 1-2 seconds. If the engine does
not start, you should not try to start it for more than 10 seconds at a time.
6. After the engine has started, let it idle for a few minutes before setting off. (Please
refer to the engine manual!)
For more detailed information, please refer to the engine manual.