Basic components
16
EMU26620
Trim meter (digital type)
This meter shows the trim angle of your out-
board motor.
NOTE:
●
Memorize the trim angles that work best
for your boat under different conditions.
Adjust the trim angle to the desired using
the power trim and tilt switch.
●
If the trim angle of your motor exceeds the
trim operating range, the top segment on
the trim meter display will blink.
EMU26650
Hour meter (digital type)
This meter shows the number of hours the
engine has been run. It can be set to show
the total number of hours or the number of
hours for the current trip. The display can
also be turned on and off.
●
Changing the display format
●
Pressing the “
” (mode) button chang-
es the display format in the following pat-
tern:
●
Total hours
→
Trip hours
→
Display off
●
Resetting the trip hours
●
Simultaneously pressing the “
” (set)
and “
” (mode) buttons for more than
1 second while the trip hours are displayed
resets the trip counter to 0 (zero).
NOTE:
The total number of hours the engine has
been run cannot be reset.
EMU26670
Water separator warning indicator
This indicator will blink when water has accu-
mulated in the water separator (fuel filter). In
such an event, stop the engine and drain the
water from the fuel filter. For further informa-
tion, see pages 23 and 50.
CAUTION:
ECM00910
Gasoline mixed with water could cause
damage to the engine.
EMU26680
Engine trouble warning indicator
This indicator will blink when the engine mal-
3. Selector switch (for fuel sensor)
ZMU01869
ZMU01870
1. Water separator warning indicator
1
ZMU01957
