Yamaha YZ250T1, Руководство по эксплуатации для владельца

Страница: 85 / 270

3-36
STEERING HEAD INSPECTION AND ADJUSTMENT
INSP
ADJ
9 Loosen the ring nut one turn.
9 Retighten the ring nut using the ring nut
wrench.
w
Avoid over-tightening.
9 Check the steering shaft by turning it lock to
lock. If there is any binding, remove the
steering shaft assembly and inspect the
steering bearings.
9 Install the plain washer
5
, handle crown
6
,
plain washer
7
, steering shaft nut
8
, Steer-
ing shaft cap 9 , handlebar 0 , handlebar
holder
q
and number plate
w
.
NOTE:
9
The upper handlebar holder should be
installed with the punched mark
a
forward.
9 Install the handlebar so that the marks
b
are
in place on both sides.
9 Insert the end of the fuel breather hose e
into the hole in the steering shaft cap.
c C
First tighten the bolts on the front side of
the handlebar holder, and then tighten the
bolts on the rear side.
Ring nut wrench:
YU-33975/90890-01403
Ring nut (initial tightening):
38 Nm (3.8 m•kg, 27ft•lb)
Steering shaft nut:
145 Nm (14.5 m•kg, 105 t•lb)
Handlebar upper holder:
28 Nm (2.8 m•kg, 20 ft•lb)
Pinch bolt (handle crown):
23 Nm (2.3 m•kg, 17 ft•lb)
Number plate:
7 Nm (0.7 m•kg, 5.1 ft•lb)
Ring nut (final tightening):
7 Nm (0.7 m•kg, 5.1 ft•lb)
1P8-28199-10 86 04.5.12, 7:42:01 PM