Yamaha YST-SW205, Руководство пользователя

Страница: 14 / 19

10
SUPERWOOFER SYSTEM YST-SW205
STANDBY/ B.A.S.S. HIGH CUT
40Hz
MOVIE
MUSIC
140Hz 10 0
VOLUME
ON
OUTPUT
+ – + –
+ – + –
INPUT
2
AUTO PHASE
STANDBY
INPUT
1
TO SPEAKERS
/MONO
LOW NORM REV
OFF HIGH
FROM AMPLIFIER
POWER
OFF
ON
3
7
5 8 1, 6
STANDBY/ B.A.S.S. HIGH CUT
40Hz
MOVIE
MUSIC
140Hz 10 0
VOLUME
ON
PHASE
NORM REV
1
Set the VOLUME control to minimum (0).
2
Turn on the power of all the other
components.
3
Make sure that the POWER switch is set to
the ON position, then press the STANDBY/
ON button to turn on the subwoofer.
* The power indicator lights up in green.
4
Play a source containing low-frequency
components and adjust the amplifier’s
volume control to the desired listening level.
5
Adjust the HIGH CUT control to the position
where the desired response can be
obtained.
Normally, set the control to the main speaker’s
rated minimum reproducible frequency*.
* The main speaker’s rated minimum
reproducible frequency can be looked up in the
speakers’ catalog or owner’s manual.
6
Increase the volume gradually to adjust the
volume balance between the subwoofer and
the main speakers.
Normally, set the control to the level where you
can obtain a little more bass effect than when this
unit is not used. If the desired response cannot
be obtained, adjust the
HIGH CUT control and
the VOLUME control again.
Before using the subwoofer, adjust the subwoofer to obtain the optimum volume and tone balance between the subwoofer and
the main speakers by following the procedures described below.
7
Set the PHASE switch to the position which
gives you the better bass sound.
Normally, set the switch to the REV (reverse)
position. If the desired response cannot be
obtained, set the switch to the NORM (normal)
position.
8
Select “MOVIE” or “MUSIC” according to the
played source.
MOVIE: When a movie type source is played, the
low-frequency effects are enhanced to allow the
listener enjoy more powerful sound. (The sound
will be thicker and deeper.)
MUSIC: When an ordinary music source is
played, the excessive low-frequency components
are cut off to make the sound clearer. (The sound
will be lighter and reproduces the melody line
more clearly.)
• Once the volume balance between the subwoofer and
the main speakers is adjusted, you can adjust the
volume of your whole sound system by using the
amplifier’s volume control.
However, if you change the main speakers to others,
you must make this adjustment again.
• For adjusting the VOLUME control, the HIGH CUT
control and the PHASE switch, refer to “Frequency
characteristics” on the next page.
ADJUSTING THE SUBWOOFER BEFORE USE
Front panel Rear panel
*Illustration shows YST-SW205.