Yamaha YST-M40, Руководство пользователя

Страница: 7 / 9

E-
4
English
About YMERSION (3D Enhancement)
YMERSION is Yamaha’s proprietary technology that enhances the spread of a normal stereo source play-
back sound, creating three-dimensional acoustics using only two speakers.
The 3D SURROUND switch on the right speaker enables you to turn the YMERSION effect on and off.
Troubleshooting
If the speakers fail to operate normally, check the following table. It lists common operation errors and simple mea-
sures that you can take to correct problems. If a problem cannot be corrected, or the symptom is not listed, discon-
nect the AC adaptor and contact your authorized YAMAHA dealer or service center for help.
Even if the (standby/on) button is turned off, a small amount of sound may be heard from the headphones if the
VOLUME control is set to max. This is normal.
If the VOLUME control is set to max. while the headphones are connected, you may hear a small amount of sound
from the speakers. This is normal.
Non skid pad
To prevent the speakers from sliding around, attach the supplied pads to the four points on
the bottom of speaker, as shown. Place the speaker on a stable, flat surface.
FAULT CAUSE CURE
No sound comes
from the speakers. The AC adaptor is not properly plugged into
the AC receptacle. Insert the AC adaptor firmly into the AC receptacle.
The (standby/on) button on the right
speaker is turned off or the AC adaptor is not
plugged into the AC receptacle and the DC
connector completely.
Plug the AC adaptor completely into the AC receptacle
and DC connector, then turn on the
(standby/on)
button on the right speaker.
The volume is set to minimum. Turn the speaker VOLUME control to the right to
increase the volume.
The level of the input signal is too low. Turn up the volume on the connected device.
Connections are faulty or incomplete. Make the connections again, firmly, or use a different
cable.
Sound is distorted. The level of the input signal is too high. Turn down the volume on the connected device.
The 3D sound can-
not be heard. The sound source is monaural. Playback the stereo source.
Noise. Connections are faulty or incomplete. Make the connections again, firmly, or use a different
cable.