Printed in Malaysia
WG29100
© 2005 All rights reserved.
This quick reference guide explains steps to connect a TV and a DVD player to this unit and achieve the surround sound effects in a quick, easy manner.
This unit creates surround sound by reflecting projected sound beams off the walls of your listening room.
The surround sound effects produced by this unit may not be sufficient when the unit is installed in the following locations.
• Rooms with surfaces inadequate for reflecting sound beams
• Rooms with acoustically absorbent surfaces
• Rooms with measurements outside the following range W (3 to 7 m) x H (2 to 3.5 m) x D (3 to 7 m)
• Rooms with less than 2 m from the listening position to the speaker positions
• Rooms where objects such as furniture are likely to obstruct the path of sound beams
• Rooms where the listening position is close to the walls
• Rooms where the listening position is not in front of this unit
Make sure you leave an adequate amount of ventilation space so that heat can escape. Make at least 5 cm of space above or below this unit.
Install this unit where there are no obstacles such as furniture obstructing the path of sound beams. Otherwise, the desired surround sound effects may not be achieved.
You may install this unit in parallel with the wall or in the corner.
Connect this unit to external components such as your TV, DVD player, VCR, digital satellite tuner, cable TV tuner, game console and a subwoofer.
■
Connecting a TV and a DVD player
Connect a TV and a DVD player to this unit. If you connect a subwoofer to this unit, you can enjoy reinforced low bass sounds.
For further information on connecting other components, see pages 14 to 20 in the supplied Owner’s Manual.
■
Installing the optimizer microphone
The supplied optimizer microphone collects and analyzes the sound that this unit produces in your actual listening environment. Refer to the following two diagrams to install the optimizer
microphone in a proper location once it is connected to this unit. If you use a tripod or the supplied cardboard microphone stand to affix the optimizer microphone, try to place the optimizer
microphone at the same height as your ears would be when you are seated in your listening position.
Before installing this unit
1. Installing this unit
YSP-800 QUICK REFERENCE GUIDE
5 cm or more
Rear
Front
Side view
40° to 50°
An object, such as furniture
Corner installation
Install this unit in the corner at a 40º to 50º angle from
the adjacent walls.
An object, such as furniture
Parallel installation
Install this unit in the exact center of the wall when it
is measured from the left and right corners.
Installation example
Install this unit so that the sound beams
can be reflected off the walls.
Wrong
Correct
Correct
2. Connecting external components to this unit
Note
OPTIMIZER MIC
1
2
L
R
VCR
SUBWOOFER
TV/STB
AUDIO INPUT
OUT
OPTICAL
DIGITAL INPUT
TV/STB
VIDEO
AUX
SYSTEM
CONNECTOR
DVD
COAXIAL
Rear panel of this unit
(U.S.A. and Canada models)
This unit
DVD player
TV
DVD video pin cable
Optimizer microphone (supplied)
Optical
digital
output
Video
output
Video
input
Analog
audio
output
Optical
digital
output
OSD video pin cable (supplied)
Subwoofer pin cable
(in case you connect a subwoofer)
Optical cable (supplied)
To the AC outlet
Audio pin cable (supplied)
Optical cable
(in case of an optical digital connection)
Subwoofer
Monaural
input
Using the supplied cardboard microphone stand
Using a tripod
Optimizer microphone position
More than 2 m
Within 1 m
Within 1 m
Tripod
Optimizer microphone position
Within 1 m
Within 1 m
Cardboard
microphone stand
More than 2 m
YSP-800 Quick Reference Guide.fm Page 1 Wednesday, July 27, 2005 8:59 PM
