Yamaha YFM400FWA 2000 5GH3-AE1, Руководство по обслуживанию

Страница: 265 / 381

7 - 22
DRIV
REAR AXLE/FINAL DRIVE GEAR AND DRIVE SHAFT
●
Remove the ring gear assembly.
●
Measure the thrust clearance. Calculate
the width of the flattened Plastigauge
®
1 .
●
If out of specification, select the correct
washer.
Ring gear thrust clearance:
0.1 ~ 0.2 mm (0.004 ~ 0.008 in)
Thrust washer selection steps:
●
Select a suitable thrust washer using the
following chart.
●
Repeat the measurement steps until the
ring gear thrust clearance is within the
specified limits.
*********************************
Thrust washer
Thickness (mm)
1.2 1.3 1.4
1.5 1.6 1.7
1.8 1.9 2.0
2.1
Ring gear stopper shim selection
1.Measure:
●
Ring gear stopper clearance “D”
Use a feeler gauge
1 .
Out of specification
→
Adjust.
2 Ring gear
3 Ring gear stopper
Ring gear stopper clearance “D”:
0.30 ~ 0.60 mm (0.012 ~ 0.024 in)