Yamaha XS650SE, Руководство по ремонту

Страница: 144 / 215

Unit: km (mi)
initial Thereafter every
Remarks
400 800 1,600 3,200 1,600 3,200 6,400
(250) (500) (1,000) (2.000) (2.000) (4.000)
Throttle grip/
Housino Apply lightly
Lithium basegrease
0
0
Hydraulic brake
fluid reserve
Use new fluid only
DOT No. 3
check check check
check check
Oil filter element
Clean/Replace as
required
0 0
0
Front forks
Drain completely Yamaha Fork Oil
Check specifications 20 wt.
0
0
Inspect thoroughly
Steering bearings Pack moderately
Medium-weight
2,800
Yearly or . . .
wheel bearing grease
Speedometer gear Inspect thoroughly
2,800
Pack moderately
Lithium base grease
Rear arm pivot
shafts
Wheel bearings
Apply grease fully
Medium-weight
2,800
wheel bearing grease
Do not over-pack Medium-weight
2,800
Yearly or . . . wheel bearing grease
Point cam
very lightly
Light-weight
0 0 0
0
cation wicks
NOTE :
Brake fluid replacement:
1. When disassembling the master cylinder or caliper cylinder, replace the brake fluid. Normally check the
brake fluid level and add the fluid as required.
2. On the inner parts of the master cylinder and caliper cylinder, replace the oil seals every two years.
3. Replace the brake hoses every four years, or if cracked or damaged.
3. Remove the drain bolt and clean with
solvent. If gasket is damaged, replace.
(PAGE 7,10 13)
24. CHASSIS
A.
Fuel petcock cleaning
1. Open the seat and remove the fuel tank
securing bolt.
2. Turn the petcock lever to the “ON” or
“RES” position. Raise the fuel tank to
remove the fuel pipe.
Drain bolt
E. Rear
brake
The rear brake pedal should be so adjusted
that it has a free play of 13 15 mm (0.51
0.59 in) from when the brake pedal is trod
to when the brake begins to be effected.
1. Loosen the adjuster lock nut (for pedal
height).
2. turning the adjuster bolt clockwise or
counterclockwise, adjust the brake pedal