Yamaha XMAX YP250R 2013, Руководство пользователя

Страница: 60 / 94

PERIODIC MAINTENANCE AND ADJUSTMENT
6-13
6
5. Install the washer and the engine
oil drain bolt, and then tighten the
drain bolt to the specified torque.
TIP
Make sure that the washer is properly
seated.
6. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
NOTICE
ECA11671

Do not use oils with a d iesel
specification of “CD” or oils of a
hi
g her quality than specifie d . In
a dd ition, d o not use oils la b ele d
“ENERGY CONSERVING II” or
hi
g her.

Be sure no forei g n material en-
ters the crankcase.
7. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
8. Reset the oil change indicator.
(See page 3-8.)
EAU20067
Final transmission oil
The final transmission case must be
checked for oil leakage before each
ride. If any leakage is found, have a
Yamaha dealer check and repair the
scooter. In addition, the final transmis-
sion oil must be changed as follows at
the intervals specified in the periodic
maintenance and lubrication chart.
1. Start the engine, warm up the final
transmission oil by riding the
scooter for several minutes, and
then stop the engine.
2. Place the scooter on the center-
stand.
3. Place an oil pan under the final
transmission case to collect the
used oil.
4. Remove the final transmission oil
filler cap and its O-ring from the fi-
nal transmission case.
Ti g htenin g torque:
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
Recommen d e d en g ine oil:
See page 8-1.
Oil chan g e quantity:
1.30 L (1.37 US qt, 1.14 Imp.qt)
U2DLE1E0.book Page 13 Friday, November 8, 2013 7:45 PM