Yamaha WR450FB 2012, Руководство по эксплуатации для владельца

Страница: 85 / 392

CABLE ROUTING
2-36
1. Lean angle sensor
2. Right handlebar switch coupler
3. Fuel sender coupler
4. Fuel pump coupler
5. Fuel pump lead
6. Headlight relay (right side of the vehicle)
7. Starting circuit cut-off relay (left side of the vehi-
cle)
8. Starter relay
9. Positive lead
10. Intake air temperature sensor coupler
11. Injector coupler
12. Joint connector
A. The diode, which is tape-bound with the lean an-
gle sensor lead, should be laid in front of the lean
angle sensor and below the lean angle sensor
lead.
B. Connect the lean angle sensor to the main har-
ness (6P).
C. Clamp the fuel pump lead and the fuel hose to-
gether. Direct the clamp allowance and the lock-
ing in any way.
D. Connect the headlight relay (on the right side of
the vehicle) to the main harness (tape-bound).
E. Connect the starting circuit cut-off relay (in the left
side of the vehicle) to the main harness (not tape-
bound).
F. Connect the positive lead to the battery positive
terminal and starter relay terminal.
G. Connect the main harness (4P) to the starter re-
lay.
H. Take care so that the radiator breather hose and
catch tank breather hose are not twisted.
I. Fasten the radiator breather hose and catch tank
breather hose to the rear frame. Clamp the hose
while locating it toward the seat rail. Tighten it to
the extend that the hose is not crushed. Lock it in
the rear of the chassis and direct the remainder
downward.
J. Clamp the catch tank breather hose and taillight
lead to the rear frame. Tighten them to the extent
that the breather hose is not crushed. Direct the
allowed portion from the locking downward.
K. Fasten to the rear frame the radiator breather
hose, catch tank breather hose, and main har-
ness. Clamp the main harness with its branch
brought up to the portion where the back stay is
connected. Tighten the breather hose to the ex-
tent that it is crushed. Lock inward of the vehicle
with the allowed portion directed downward.
L. Lay out the diode in the rear left of the battery.
M. Connect the negative lead to the battery negative
terminal.
N. Pass the two branches from the main harness
through the hole in the relay holder.
O. Connect the negative lead coupler (1P) to the
main harness. Lay out the negative lead coupler
between the starter relay and rear frame.
P. Pass the starter motor lead and negative lead
through the hole in the relay holder.
Q. Put in the spark plug so as to allow the high ten-
sion cord to pass above the cylinder head cover
bolts.
R. Insert the joint connector down in the bracket and
fix it.
S. Insert the main harness clip firmly in the round
hole in the bracket and fix it.
T. Connect the AC magneto coupler (2P) to the
main harness.
U. Connect the regulator coupler (2P) to the main
harness.
V. Connect the neutral switch coupler (1P) to the
main harness.
W. Connect the regulator coupler (3P) to the AC
magneto lead.
X. Lay out the joint connector 1 to the left of the lean
angle sensor.