Yamaha WR450FB 2012, Руководство по эксплуатации для владельца

Страница: 103 / 392

PERIODIC MAINTENANCE
3-12
6. Adjust:
• Throttle grip free play
Refer to “ADJUSTING THE THROTTLE
GRIP FREE PLAY” on page 3-29.
EAS1DX3085
CHECKING THE EXHAUST SYSTEM
The following procedure applies to all of the ex-
haust pipes and gaskets.
1. Remove:
• Exhaust pipe protector
2. Check:
• Exhaust pipe
• Muffler
Cracks/damage
o
Replace.
Refer to “ENGINE REMOVAL” on page 6-1.
• Gasket
Exhaust gas leaks
o
Replace.
Refer to “ENGINE REMOVAL” on page 6-1.
3. Check:
• Tightening torque
4. Install:
• Exhaust pipe protector
EAS1DX3086
CHECKING THE ENGINE OIL LEVEL
1. Stand the vehicle on a level surface.
TIP
• Place the vehicle on a suitable stand.
• Make sure the vehicle is upright.
EWA1DX1002
WARNING
Never remove the oil tank cap just after high
speed operation. The heated oil could spurt
out causing danger. Wait until the oil cools
down to approximately 70°C (158°F).
2. Idle the engine more than 3 minutes while
keeping the machine upright. Then stop the
engine and inspect the oil level.
3. Remove:
• Oil tank cap “1”
4. Inspect:
• Oil level
Check that the engine oil is above the level
mark “a” and that the oil does not come out
when the check bolt “1” is removed.
Below the level mark “a”
o
Add oil through
the filler cap hole until it is above the level
mark “a”.
Oil comes out at the check bolt
o
Drain the
oil until it stops coming out.
TIP
When inspecting the oil level, do not screw the
oil level gauge into the oil tank. Insert the gauge
lightly.
Throttle grip free play
3.0–5.0 mm (0.12–0.20 in)
Exhaust pipe bolt and nut “1”
20 Nm (2.0 m·kgf, 14 ft·lbf)
Exhaust pipe and muffler bolt “2”
16 Nm (1.6 m·kgf, 12 ft·lbf)
Muffler and muffler bracket bolt
“3”
30 Nm (3.0 m·kgf, 22 ft·lbf)
T
R
.
.
1
2
3
Exhaust pipe protector screw
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®
T
R
.
.