INSTRUMENT AND CONTROL FUNCTIONS
3-4
2
3
4
5
6
7
8
9
TIP
Indicator “
” comes on when tripmeter
A is selected, and indicator “
” comes
on when tripmeter B is selected.
To reset a tripmeter, select it by push-
ing the “SLCT 2” button, and then push
the “RST” button for at least one sec-
ond.
Clock
The clock displays when the main
switch is pushed to “ON”.
To set the clock
1. Push the “SLCT 1” button for at
least two seconds.
2. When the hour digits start flashing,
push either select button to set the
hours.
3. Push the “RST” button, and the
minute digits will start flashing.
4. Push either select button to set the
minutes.
5. Push the “RST” button, and the
second digits will start flashing.
6. Push either select button to set the
second digits to zero.
7. Push the “RST” button for at least
two seconds, and then release it to
start the clock.
TIP
When setting the clock, push the
“SLCT 1” button to increase the
digits or “SLCT 2” button to de-
crease the digits. Pushing and
holding either button will increase
or decrease the digits continuously
until the button is released.
If a button is not pushed within 30
seconds while setting the clock,
the clock will be set to the currently
displayed time.
Changing from the basic mode to
the measurement mode
With the odometer selected, push the
“SLCT 1” button and “SLCT 2” button
together for at least two seconds to
change to the measurement mode.
Changing from the measurement
mode to the basic mode
TIP
The stopwatch must be stopped before
changing to the basic mode.
1. Check that the stopwatch is not in
operation. If the stopwatch is in op-
eration, stop it by pushing the
“SLCT 1” button and “SLCT 2” but-
ton together.
2. Push the “SLCT 1” button and
“SLCT 2” button together for at
least two seconds to change to the
basic mode.
Measurement mode (for the stop-
watch)
When the measurement mode is se-
lected, the stopwatch is displayed and it
can be started manually or automatical-
ly.
1. Tripmeter B indicator “
”
1
1DX-9-E2.book 4 ページ ２０１３年２月２６日 火曜日 午後２時３４分
