Yamaha VZ200R, Руководство пользователя

Страница: 30 / 96

Components
24
EMU32052
Power trim and tilt switch on remote
control
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch “
” (up) trims the
outboard motor up, and then tilts it up. Press-
ing the switch “
” (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position. For instructions
on using the power trim and tilt switch, see
pages 55 and 57.
EMU26153
Power trim and tilt switch on bottom
engine cowling
The power trim and tilt switch is located on
the side of the bottom engine cowling. Press-
ing the switch “
” (up) trims the outboard
motor up, and then tilts it up. Pressing the
switch “
” (down) tilts the outboard motor
down and trims it down. When the switch is
released, the outboard motor will stop in its
current position.
For instructions on using the power trim and
tilt switch, see page 57.
WARNING
EWM01030
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
while the boat is moving could increase
the risk of falling overboard and could
distract the operator, increasing the risk
of collision with another boat or an obsta-
cle.
EMU26244
Trim tab with anode
WARNING
EWM00840
An improperly adjusted trim tab could
cause difficult steering. Always test run
after the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
UP
DN
ZMU01862