Yamaha VX110 Sport, Руководство по обслуживанию

Страница: 186 / 347

5-87
E
POWR
CONNECTING RODS AND PISTONS
Connecting rod inspection
1. Measure:
• Big end oil clearance
Out of specification
→
Replace the big
end bearings.
Big end oil clearance:
0.016–0.040 mm
(0.0006–0.0016 in)
Measurement steps:
The following procedure applies to all of the
connecting rods.
CAUTION:
Do not interchange the big end bearings
and connecting rods. To obtain the cor-
rect big end oil clearance and prevent
engine damage, the big end bearings
must be installed in their original posi-
tions.
• Clean the big end bearings, crankshaft
pins, and the inside of the connecting rod
halves.
• Install the big end upper bearing into the
connecting rod and the big end lower
bearing into the connecting rod cap.
NOTE:
Align the projections
a
on the big end bear-
ings with the notches
b
in the connecting
rod and connecting rod cap.
• Put a piece of Plastigauge
1
on the
crankshaft pin.
• Assemble the connecting rod halves.
1