Tyros4 Owner’s Manual
109
Install
ing the
Optional Flash Memor
y Expansion Module
3
Remove the four screws from the cover.
4
Insert the module into the socket by fol-
lowing the procedure below.
4-1
Insert the module vertically in the socket and
position the screws (of the module) to the
female screws respectively.
4-2
Press the top of the connector as shown, then
push the connector firmly into the socket.
4-3
Tighten each screw of the module to each
female screw of the Tyros4 with your hand as
shown.
5
Re-install the cover you removed in step
3, in reverse order.
6
Check that the installed module is func-
tioning properly.
6-1
Set the Tyros4 right-side up, and then turn the
power on.
6-2
Call up the Format operation display.
[VOICE CREATOR]
[E] EXPANSION
MODULE
6-3
Execute the Format operation following the
messages on the display.
If the module has been installed properly, the appro-
priate available memory size is indicated in the
PROPERTY display.
([VOICE CREATOR]
[E] EXPANSION MOD-
ULE
[7
]–[8
] PROPERTY)
Removing Flash Memory Expansion
Module
1
Loosen both the screws with your hand
as shown below.
2
Pull the module vertically out of the
socket.
3
Attach the cover to the bottom panel.
Keep the removed screws in a safe place. They will be used when reattaching the
cover to the instrument after installation.
(Rear side)
NOTE
Flash Memory
Expansion Module
Connector
Female screw
Socket
Female screw
(Rear side)
4-3
4-2
• If you cannot loosen the screws with your hand, use a Phillips
screwdriver. In this case, be careful NOT to scratch the module or
the Tyros4.
• Be careful NOT to drop the screws inside the instrument when loos-
ening them.
1
2
NOTICE
